EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 03:25 AM . Last Modified: 2024-04-05 03:19 AM
Hi team,
When I change the name of the network port of the genome AP4421.
from 'Ethernet' to 'APC LAN'
and save
DCO client restarts and changes are not saved.
same issue with rack ATS AP7721
no issue with rack pdu AP7853
workaround:
add the genome (without changes) to the model
make changes on the device in the model
Please look at the issue.
Regards,
(CID:127535387)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 03:25 AM . Last Modified: 2024-04-05 03:19 AM
Hi Eduard,
Good catch, I can confirm your observation - I have now registered an enhancement case for this.
Your suggested work around is fine!
Many thanks for reporting,
Kind regards
(CID:127535427)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 03:25 AM . Last Modified: 2023-10-22 04:30 AM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.