Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84863members
354353posts

configuración UPS en DCO 8.3.2

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
2
243

configuración UPS en DCO 8.3.2

This question was originally posted on DCIM Support by Raul Velasquez Achury on 2019-08-15


buenas tardes, me pueden informar como realizo esta configuración en DCO, quedo atento a sus comentarios, gracias.

(CID:147784991)

2 Replies 2
DCIM_Support
Picard
Picard
0 Likes
0
243

Re: configuración UPS en DCO 8.3.2

This answer was originally posted on DCIM Support by Jef Faridi on 2019-08-16


Hi Raul,

Modelling parallel UPSs (in DCO) are unfortunately not directly supported, as sort of work around you might want to create a single UPS (with the combined capacity of the two UPSs) and set the Internal redundancy on the UPS to N+1.

In order to get the associations from DCE to work, you might want to create another UPS object with zero capacity (without power cabling) and place it next to the "main" UPS in DCO. In that way, you get a UPS model where you can associate DCE alarms.

Kind regards

(CID:147785100)

DCIM_Support
Picard
Picard
0 Likes
0
243

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.