A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.
Send a co-worker an invite to the Exchange portal.Just enter their email address and we?ll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
seems like on symmetra px500 DCE reading only the highest temperature value and not realtime temperature of batteries
since value can increase for couple of minutes I think it is better to read realtime value
attached screens
Until last week the threshold was set on 35degrees but in the we the value generate alarm even if the temperature increasing for couple of minutes (because of batteries maintenance check maybe?)