EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 06:55 PM . Last Modified: 2024-04-04 11:23 PM
I have to install another PDU as Generator source.
Also I am unable to use ATS as a source for the UPS or another PDU.
(CID:132652196)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 06:55 PM . Last Modified: 2024-04-04 11:23 PM
Hi Boris,
That is basically not possible (that may require another type of capacity calculations, which are not supported), currently the supported power path (in DCO) can be started from UPS, PDU and Power Panel.
Kind regards
(CID:132652408)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 06:55 PM . Last Modified: 2023-10-22 04:21 AM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.