Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84689members
354048posts

Temperature measurements in IT Advisor web interface

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

sesa86716
Cadet
Cadet
0 Likes
1
441

Temperature measurements in IT Advisor web interface

Hello

in the web interface of  IT Advisor we can see temperature measurements on the floor layout and also on the right site as a list of sensors. In the room layout all sensors are showing temperature without comma values, at the same time on the list you see some sensors having  a value after comma - see attached picture. Is there a way to show value after comma on the room layout? Why there is a difference between the way how the values are being visible in room layout and on the list? 

 

Sensorwerte im A-1-010.png

Tags (1)
1 Reply 1
Jef
Captain Captain
Captain
0 Likes
0
429

Re: Temperature measurements in IT Advisor web interface

Hi Michal,

I think it is due to predefined space it is designed that the temperature/sensor values should be displayed as 2 digit integers, for example 23.8 being rounded and displayed as 24. So you would like more digits (such as 23.8) being displayed, I can capture this as a product feedback and share with management team, thanks.

Kind regards,

Jef 

 

Tags (1)