Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84643members
353975posts

Socomec NetVision (V6.2) Card

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
1
303

Socomec NetVision (V6.2) Card

This question was originally posted on DCIM Support by Eva on 2019-11-26


We installed a NetVision Card (V6.20) to Socomec UPS (MAGP 100), and downloaded the "socomec_netvision7.xml" ddf file and added to DCE (V7.5.0.62) completely.  However, the error shown on the DCE that "A problem has been encountered in the communications between the agent and the UPS" after run discovery.  Appreciate that someone help to share the experience or provide the solution for ref.  Thanks.

(CID:152078785)

1 Reply 1
DCIM_Support
Picard
Picard
0 Likes
0
303

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.