Representing a rack shelf that extends outward

[DCIM_Support]

I have a shelf in my rack that permanently extends outward from the front rack. How to I account for this, spatially, on my rack in my electrical room?

I also need to make it 2u, and the shelf in the master Genome is 1u and there is no way to change that under "Properties."

(CID:143758943)

[DCIM_Support]

I do not think its possible to have an asset extend through the front. When I extend assets beyond the rack depth it appears they extend through the rear side of the rack.

I have not found a way to extend a device through the front.

I doubt you'd want to place the racks backwards in this case.

Regards

Greg Sterling

(CID:143760242)

[DCIM_Support]

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.