Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84795members
354243posts

Rack Temperature sensor installation

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

amitshm
Ensign
Ensign
0 Likes
0
274

Rack Temperature sensor installation

Hi,

I would like to measure the temperature on the front door of a rack in three places.

Also I need to measure the temperature on the back door of the rack.

I’m using AP8886 PDU and AP9335T sensors. I have two PDU per rack.

The PDU have only one RJ port for sensory.

 

Is there any solution like a splitter or a sensor harness?

Is there another wired sensor that can be more appropriate?

I’m familiar with the NetBotz but I wouldn’t like to implement this in that case (short of U and space).

Any idea?

 

Another issue, with the AP9335T, how far can it extended it using the NetBotz550 or the AP8886 PDU?

 

Thanks

Regards

 

Amit

Tags (1)