Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84293members
353432posts

Rack Monitoring 550 Error!

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

omelak
Crewman
Crewman
0 Likes
1
534

Rack Monitoring 550 Error!

Hello all,
I'm getting the mentioned-below error on NetBotz Rack Monitoring 550. I have never used one before and was wondering if anyone knew how to change where it is saving its data.

 

Description;

  • The system was configured to use an add-on or network drive for storing captured data, but the drive was unable to be found or initialized.
  • Captured data is being stored in RAM.

Alert Type;

  • Drive Not Found Severity
  • Failure Alert Level
  • First Alert Level - repeat 2 Access information
  • d Pod
  • NetBotz Rack Monitor 550

Any advice will be very appreciated...

 

Tags (1)
1 Reply 1
APC_Steve
Commander Commander
Commander

Re: Rack Monitoring 550 Error!

Hi @omelak ,

 

If the appliance had been saving data on an external drive, the configuration would be made in advanced view under the external storage applet:

 

 

Tags (1)