Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84861members
354342posts

PAM server with Cyberark

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
2
231

PAM server with Cyberark

This question was originally posted on DCIM Support by Lukas Jegerlehner on 2018-07-17


is there a way to connect all APC devices (UPS, PDUs, etc.) to a Pam server and a cyberark solution, which will manage the users and passwords for all APC devices?

(CID:132665661)

2 Replies 2
DCIM_Support
Picard
Picard
0 Likes
0
231

Re: PAM server with Cyberark

This answer was originally posted on DCIM Support by Steven Marchetti on 2018-07-17


Hi Lukas,

 

We have no specific integration with Cyberark. I do not know enough about the software from my limited browsing for it's options and protocols but I do not believe the APC NMC (used in the PDUs, UPS, cooling units, etc) and this software use the same protocols. If you can get more information and have specific questions about the options used by the NMC, we may be able to better answer your question.

 

Steve

(CID:132665729)

DCIM_Support
Picard
Picard
0 Likes
0
231

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.