EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 07:10 PM . Last Modified: 2024-04-03 02:44 AM
I have placed a double door in my wall and, in 3D mode, notice that the door frame is positioned outside of the room. I would like to move the door so that it renders correctly in 3D mode, but the door snaps to the wrong position every time, placing the door approximately 8" outside of the room.
Thank you in advance for your help.
(CID:143756498)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 07:10 PM . Last Modified: 2024-04-03 02:44 AM
Try zooming in to the wall section where you can drag/drop the door on top of the wall section.
(CID:143758137)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 07:10 PM . Last Modified: 2023-10-22 03:05 AM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.