More than one ATS in a rack is not allowed

DCIM_Support · ‎2020-07-04

This question was originally posted on DCIM Support by Javier Zurera on 2018-02-01

Hi Team,

We are deploying a new DC over DCO 8.2.2 and we try to model more than one ATS in a rack and DCO says that this is not allowed.

How can we do that?

DCIM_Support · ‎2020-07-04

This answer was originally posted on DCIM Support by Jef Faridi on 2018-02-01

Hi Javier,

That's correct, it seems currently not supported to configure power dependency for several rack ats (in the same rack), being connected to rack pdus (feed A and feed B).

I have recently logged an enhancement case for this.

Thanks,

Kind regards

See Answer In Context

DCIM_Support · ‎2020-07-04

This answer was originally posted on DCIM Support by Jef Faridi on 2018-02-01

Hi Javier,

That's correct, it seems currently not supported to configure power dependency for several rack ats (in the same rack), being connected to rack pdus (feed A and feed B).

I have recently logged an enhancement case for this.

Thanks,

Kind regards

DCIM_Support · ‎2020-07-04

This comment was originally posted on DCIM Support by Javier Zurera on 2018-02-01

Thank you Jef.

DCIM_Support · ‎2020-07-04

This comment was originally posted on DCIM Support by Jef Faridi on 2018-02-01

You are most welcome, Javier

Kind regards

DCIM_Support · ‎2020-07-04

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.