ITA - Power Path Configuration

[Tafadzwa]

Hi All,

Please advise what is the best practice in the following instance when configuring Power Path in ITA. I have a 3 Phase UPS that is supplying power to a 3 Phase Distribution Board that has single phase 32 A Breakers that fed Single Phase Rack PDUs however when I do the configs using this logic, I am getting "The Rack PDU Voltage does not match the the output Voltage of the Connected PDU/Power Panel".

When I use a single phase Power Panel I do not get any Alarm however that is not what is in the DC.

How can I go about this?

Screenshots attached.

Thank you for any assistance.

@Jef 

@gsterling 

@APC_Steve 

[gsterling]

Hello Mr. T. which rack pdu are you using in your above example? Whats its make and model?

Regards

Greg Sterling

[Tafadzwa]

Hi Greg,

Thank you for responding.

I am using Raritan R-PDU, Model: PX2-2493

Regards,