EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 02:54 PM
This question was originally posted on DCIM Support by Vincenzo Fantino on 2018-03-07
After I associate a device in DCO, the device sensors temperature are in celsius, how I change it to fahrenheit?
Thanks
Enzo
(CID:129404419)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 02:54 PM
This answer was originally posted on DCIM Support by Avinash A N on 2018-03-08
Hi Vincenzo,
Thanks for posting here. You have to go to tools-> preferences-> general
and change the "system of measurement" to US.
Please let us know if you face any problem to find it.
Regards,
Avinash A N
(CID:129404481)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 02:54 PM
This comment was originally posted on DCIM Support by Vincenzo Fantino on 2018-03-08
Found it, thanks
(CID:129406564)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 02:54 PM . Last Modified: 2023-10-22 02:17 AM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.