Ask our Experts
Didn't find what you are looking for? Ask our experts!
Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Recommended Forums
Link copied. Please paste this link to share this article on your social media post.
Hello
I need to connect San module port to a patch panel and from the patch to the server.
How do I have to configure the module and the patch to do this?
One 48 port module is for one patch panel by raw in my configuration
I put a picture to explain my request.
Hope it's clear 😀
Many Thanks
Best Regards
Rocchino
Link copied. Please paste this link to share this article on your social media post.
Hi Rocchino,
In the following example I have 3 items: San Module, patch panel and server, configured with "Fiber" network:
I'm using the "Connection tool":
to connect san module (front side, port 1) to patch panel (back side, port 1):
and then connect patch panel (front side, port 1) to server (front, port 1):
that's it, I think that might be the network roue we wanted to make:
Kind regards
Link copied. Please paste this link to share this article on your social media post.
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.