Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84248members
353347posts

DG fuel monitoring solution

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
3
211

DG fuel monitoring solution

This question was originally posted on DCIM Support by Vineet K. Sarin on 2014-06-15


Do we have a solution to monitor fuel consumption of a Diesel Generator and also able to monitor how much time DG has been running at the same time?

I'm looking out for SE solution and not for any third party solution. It would be great if we can integrate the same with our DCE as well.

(CID:84639756)

3 Replies 3
DCIM_Support
Picard
Picard
0 Likes
0
211

Re: DG fuel monitoring solution

This answer was originally posted on DCIM Support by VSales on 2014-06-16


Hello Vineet,

StruxureWare Data Center Expert is able to communicate with device via SNMPv1, SNMPv3 and Modbus/TCP. If the generate has the ability to communicate with one of those protocols then Data Center Expert is able to poll device data and alert based on thresholds. If the generator can monitor monitors fuel level then that information can be polled by Data Center Expert. 

(CID:84836392)

DCIM_Support
Picard
Picard
0 Likes
0
211

Re: DG fuel monitoring solution

This answer was originally posted on DCIM Support by Vineet K. Sarin on 2014-06-17


What I'm looking for is a complete solution where the complete DG Control and monitoring has to be done by our solution. I was looking at some Gas and Oil Industry solutions  from SE and feel we should have some of these solutions which will make us pick up such orders without involving third party automation systems.

(CID:84836401)

DCIM_Support
Picard
Picard
0 Likes
0
211

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.