Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84863members
354353posts

DCO VM snap shot

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

DCIM_Support
Picard
Picard
0 Likes
3
160

DCO VM snap shot

This question was originally posted on DCIM Support by Eitan Nachman on 2018-11-15


Can i make snap shot of the DCO VM and load it in another ESXi?

(CID:135433496)

3 Replies 3
DCIM_Support
Picard
Picard
0 Likes
1
160

Re: DCO VM snap shot

This answer was originally posted on DCIM Support by Jef Faridi on 2018-11-15


Hi Eitan,

By taking the vm host snap shot you would also have the servers (DCO) network configurations included, not sure how the server would function/behave when re-imaged/load it in another ESXI. Perhaps re-configuring the network settings may or may not work, however the best recommendation is to use the DCO's build-in backup/restore feature. 

Kind regards

(CID:135433555)

DCIM_Support
Picard
Picard
0 Likes
0
160

Re: DCO VM snap shot

This comment was originally posted on DCIM Support by Eitan Nachman on 2018-11-18


Thanks

(CID:135434430)

DCIM_Support
Picard
Picard
0 Likes
0
160

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.