Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84484members
353702posts

DCO Rack Location : Grid reference lost when using Rows

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

Solved
DCIM_Support
Picard
Picard
0 Likes
2
258

DCO Rack Location : Grid reference lost when using Rows

This question was originally posted on DCIM Support by Wes Burhoe on 2018-06-15


Hi all, Just noticing we lose grid location detail in the racks automatic Location string. For large sites such as our, this becomes a workflow issue and also affects our ability to pin point a racks location via RESTapi's... ETL exports, etc.

 


Our teams are trained on how to spot the grid reference along the bottom in the DCO client but ideally, to future proof and reduce the human element here it would be good if the Location field simply injected the Row label.. for example if the "R-F8" rack in the screenshot was in ROW-1 (meaning we would extend the row to include it) the Location path would look like..."F8/ROW-1/CAGE-1/UAT".

(CID:132653360)


Accepted Solutions
DCIM_Support
Picard
Picard
0 Likes
0
258

Re: DCO Rack Location : Grid reference lost when using Rows

This answer was originally posted on DCIM Support by Jef Faridi on 2018-06-18


Hi Wes,

Could be reproduced, I have registered an enhancement case for this.

Thanks,

Kind regards

(CID:132653623)

See Answer In Context

2 Replies 2
DCIM_Support
Picard
Picard
0 Likes
0
259

Re: DCO Rack Location : Grid reference lost when using Rows

This answer was originally posted on DCIM Support by Jef Faridi on 2018-06-18


Hi Wes,

Could be reproduced, I have registered an enhancement case for this.

Thanks,

Kind regards

(CID:132653623)

DCIM_Support
Picard
Picard
0 Likes
0
258

🔒 Closed

This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.