EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-03 05:05 AM . Last Modified: 2024-04-08 11:27 PM
Is there a way to "pause" DCO polling an individual DCE external system whilst retaining the device associations?
DCO 7.5 and DCO 8
(CID:107448062)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-03 05:05 AM . Last Modified: 2024-04-08 11:27 PM
Hi Ed,
There is no supported feature to pause DCO polling for an individual DCE external system, but as a sort of work-around you might want to try to set the polling intervals as high as possible and the timeouts as low as possible (in the external systems configurations). You might also want to try disabling the "Retrieve sensors", that would disable retrieving humidity and temperature sensors (but not the power data).
Kind regards
(CID:107448228)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-03 05:05 AM . Last Modified: 2023-10-31 10:50 PM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.