EcoStruxure IT forum
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 08:18 PM . Last Modified: 2024-04-03 01:16 AM
Hello
The dce was running without problems. We changed the ntp server configuration and time zone through the client. After saving the changes, a message appears to restart the server. After this process we never get access via web or client.
DCE 7.2.4 is running in vmware. In the vmware console we were able to verify that the DCE started without errors.
I am checking in the it manager if there has been any change in the network (domains, firewall, etc).
In attached i send some print screen.
I restart DCE and i can see that httpd service fail to start.
(CID:146276701)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 08:18 PM . Last Modified: 2024-04-03 01:16 AM
Hi Miguel,
I would suggest to contact your local technical support to have this looked at. Seeing the error shows that the httpd service did not start correctly. Your local technical support should be able to assist you further on this issue.
Regards,
John
(CID:146278237)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-05 08:18 PM . Last Modified: 2023-10-22 01:09 AM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.