EcoStruxure IT forum
A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.
Posted: 2020-07-05 04:53 PM
This question was originally posted on DCIM Support by Alessio De Maio on 2019-02-06
Hello everyone,
is there a way to edit the single phase in the breaker panel? I need it to be something like "L1 - L2 - L2 - L1 - L3 - L1" and not "L1 - L2 - L3 - L1 - L2 - L3". I do not need them in order. I need to choose a specific phase in a specific position.
The power panel is a "GEN_3P_POWER_PANEL".
Thank you everyone.
(CID:139692610)
Posted: 2020-07-05 04:53 PM
This answer was originally posted on DCIM Support by Jef Faridi on 2019-02-06
Hi Alessio,
Sorry, no that's not supported. Phase breaker numbers/values can be edited but not the phase name or its order.
Kind regards
(CID:139692697)
Posted: 2020-07-05 04:53 PM
This answer was originally posted on DCIM Support by Jef Faridi on 2019-02-06
Hi Alessio,
Sorry, no that's not supported. Phase breaker numbers/values can be edited but not the phase name or its order.
Kind regards
(CID:139692697)
Posted: 2020-07-05 04:53 PM
This comment was originally posted on DCIM Support by Alessio De Maio on 2019-02-06
Hi Jef,
what do you mean with phase numbers/value?
Thank you
(CID:139692721)
Posted: 2020-07-05 04:53 PM
This comment was originally posted on DCIM Support by Jef Faridi on 2019-02-06
Hi Alessio,
In the following illustration, breaker/number 10 is changed to 30:
Kind regards
(CID:139692726)
Posted: 2020-07-05 04:53 PM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Create your free account or log in to subscribe to the forum - and gain access to more than 10,000+ support articles along with insights from experts and peers.