Ask our Experts
Didn't find what you are looking for? Ask our experts!
Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Link copied. Please paste this link to share this article on your social media post.
Hello,
I've created a virtual sensor to add the total active power of 3 UPS systems.
When the sensor is created first it displays the kW value as I have the Map set to "Show Value, Active Power Total)
After an undefined amount of time the value disappears.
The other virtual sensors on the same map view are fine.
Hovering over the sensor still reveals the value
Any ideas?
Regards,
Brendan.
Link copied. Please paste this link to share this article on your social media post.
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.