Ask our Experts
Didn't find what you are looking for? Ask our experts!
Schneider Electric support forum about installation and configuration for DCIM including EcoStruxure IT Expert, IT Advisor, Data Center Expert, and NetBotz
Search in
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 01:48 PM . Last Modified: 2024-04-05 02:50 AM
(CID:128751879)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 01:48 PM . Last Modified: 2024-04-05 02:50 AM
Hi Arun,
What is the version of your DCO?
I had seen similar issue, that 3D temperature map (based on measurements) would have needed to be refreshed manually. However, there have been applied improvements since 8.2.1 that should help. Please upgrade, if you are using one of the previous versions, thanks.
Kind regards
(CID:128751922)
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2020-07-04 01:48 PM . Last Modified: 2023-10-20 05:09 AM
This question is closed for comments. You're welcome to start a new topic if you have further comments on this issue.
Link copied. Please paste this link to share this article on your social media post.
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.