Ask our Experts
Didn't find what you are looking for? Ask our experts!
Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Recommended Forums
Link copied. Please paste this link to share this article on your social media post.
Hi everyone. We are still new in EAE and still learning.
We are working on a project with the following configuration: -
- M580 dPAC - the main controller
- STB - the remote I/O
- Aveva InTouch - the HMI
Below is the simplified system architecture.
The STB island consists of AI, DI and DO modules and all signals are mapped to EAE using SYMLINKMULTIVARDST and SYMLINKMULTIVARSRC function blocks. The signals are expected to be displayed on HMI via OPC UA protocol.
So far, we managed to get STB DI and DO signals listed in OPC UA (refer EAE ver.24 OPC UA Exposed List.png) but not for AI signal. The AI symbolic link configuration as shown by the attached snapshot (refer STB AI Symlink.png).
Kindly guide us on how to get the AI signals to be listed in OPC UA. Thanks.
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.