How to configure an analog input on a DMS MicroSmart controller as a contact input. - Schneider Electric Community

Notifications

Building Automation Knowledge Base

Schneider Electric Building Automation Knowledge Base is a self-service resource to answer all your questions about EcoStruxure Building suite, Andover Continuum, Satchwell, TAC…

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Related Forums

Intelligent Devices Forum

Previous Next

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to Building Automation Knowledge Base

883 Views

Link copied. Please paste this link to share this article on your social media post.

Trying to translate this page to your language?

Select your language from the translate dropdown in the upper right.

Translate to: English

Issue

How to configure an analog input on a DMS MicroSmart controller as a contact input.

Environment

MSC-MPC (revision 10) and MSC-MPC-001 (revision 11) MicroSmart controllers

Cause

No contact inputs available on the MSC-MPC

Resolution

Below are illustrations and explanations on how to configure an analog input as a contact input.

To The Top!

Terms & Conditions Privacy Notice © 2024 Schneider Electric, Inc