Mass configure APC devices using Data Center Expert asministrator ?

Notifications

Join our "Ask Me About" community webinar on May 20th at 9 AM CET and 5 PM CET to explore cybersecurity and monitoring for Data Center and edge IT. Learn about market trends, cutting-edge technologies, and best practices from industry experts.
Register and secure your Critical IT infrastructure

APC UPS Data Center & Enterprise Solutions Forum

Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

5060

196

112

108

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to APC UPS Data Center & Enterprise Solutions Forum

643

Link copied. Please paste this link to share this article on your social media post.

Hello,
I need to mass configure 100 UPSes with a new Administrator user. I use Data Center Expert 7.9.3 and APC SNMP device configuration, User configuration, Create/Modify User. My problem is that it is only User and password that comes out to the UPS NMC card AP9631.
Then you have to go into each UPS and set all the values again and enable the account. Shouldn't DCE be able to configure all the values directly.

Replies 0

never-displayed

You must be signed in to add attachments

never-displayed

To The Top!

Mass configure APC devices using Data Center Expert asministrator ?

Mass configure APC devices using Data Center Expert asministrator ?

This is a heading