How to replace a MicroLogic 6.0X Control Unit

Notifications

Ask Me About Webinar: Data Center Assets - Modeling, Cooling, and CFD Simulation
Join our 30-minute expert session on July 10, 2025 (9:00 AM & 5:00 PM CET), to explore Digital Twins, cooling simulations, and IT infrastructure modeling. Learn how to boost resiliency and plan power capacity effectively. Register now to secure your spot!

Ask the Community

Ask questions, get advice from experts and peers on Digital Automation & Energy Management.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to Ask the Community

Link copied. Please paste this link to share this article on your social media post.

Hello everyone,

I recently encountered an issue at a project site where the MicroLogic 6.0X control unit display is flickering. Based on our assessment, it is likely a control unit malfunction.

May I ask if there is any installation manual or instructional video available in case we proceed to replace the control unit ourselves?

There are multiple sensor wiring harnesses connected at the rear of the unit, and we are unsure of the correct procedure for disconnection and reinstallation.

Thank you all in advance for your support.

Replies 0

never-displayed

You must be signed in to add attachments

never-displayed

To The Top!

How to replace a MicroLogic 6.0X Control Unit

How to replace a MicroLogic 6.0X Control Unit

Welcome!