Control Expert Simulator and Operator Terminal Simulator connection fails with message "PLC connection failed. Automatic retu...

Notifications

Launch of Consumer/Home Owner registration process!
We are pleased to announce the commencement of the Consumer/Home Owner Registration Process on Community. Consumers/Home Owners may now proceed to register by clicking on Login/Register. The process is straightforward and designed to be completed in just a few steps.

Ask the Community

Ask questions, get advice from experts and peers on Digital Automation & Energy Management.

Search in

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to Ask the Community

Start a Topic

665

Link copied. Please paste this link to share this article on your social media post.

The control expert simulator seems to run fine until the operator terminal simulator is started. The control expert PLC code goes offline with message saying "PLC connection failed. Automatic return to off-line mode". The operator terminal simulator stays on communicating with the simulator. However only when it is closed, the control expert PLC code can go online with its simulator.

Please suggest the solution for this issue.

Replies 0

never-displayed

You must be signed in to add attachments

never-displayed

You’ve reached the end of your document

Ask our Experts

Didn't find what you are looking for? Ask our experts!

My Dashboard

Check out the new Feeds and activities that are relevant to you.

To The Top!