Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Link copied. Please paste this link to share this article on your social media post.
I need clarification regarding the communication setup between the TM241C40T PLCs and the HMIGTO5310 HMI. The communication protocol used is Modbus TCP/IP, and I’m utilizing the TM4ES4 switch module for Modbus TCP connectivity.
There are four sets of PLCs (TM241C40T with TM4ES4) communicating with the HMIGTO5310 via a managed Ethernet switch. However, the TM4ES4 module displays the protocol as "Machine Expert Protocol" when communicating between the PLCs and the HMI.
I would like to confirm whether any standard managed Ethernet switch can be used for this setup, or if a specific type of managed switch is required to ensure proper communication.
Refer the attachment for communication architecture.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.