Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84783members
354228posts

Could someone please help me?

APC UPS for Home and Office Forum

Schneider Electric support forum for our APC offers including Home Office UPS, Surge Protectors, UTS, software and services and associated products designed to share knowledge, installation, and configuration.

Solved
rucanunes_apc
Cadet
0 Likes
3
159

Could someone please help me?

This was originally posted on APC forums on 6/1/2009


Hello,

I bought a Mustek Power Must 848 but when the power fails the UPS shuts down and the RED light (fault) goes on.
I have a Tower with 6 HDs, two DVDs, 6 Fans, etc, a 24” monitor and an ASUS eeebox 202 connected to the UPS.

If I only leave the Asus eeeBox connected to the UPS + the monitor and disconnect the UPS from the main outlet,
the UPS enters battery mode, BUT if I connect my Tower to the UPS and disconnect the UPS from the Main outlet,
than the UPS shuts down and the RED light (fault) lights up.

What seems to be the problem here? Is it a “small” UPS for my Configuration?

All the best,
Ralph Nunes


Accepted Solutions
BillP
Administrator Administrator
Administrator
0 Likes
0
159

Re: Could someone please help me?

This reply was originally posted by Angela on APC forums on 6/2/2009


ok so that is the model of the UPS? because that is not an APC model..so thats why i am confused.

See Answer In Context

3 Replies 3
rucanunes_apc
Cadet
0 Likes
0
159

Re: Could someone please help me?

This was originally posted on APC forums on 6/2/2009


Mustek Power Must 848

BillP
Administrator Administrator
Administrator
0 Likes
0
158

Re: Could someone please help me?

This reply was originally posted by Angela on APC forums on 6/1/2009


what model UPS do you have? it should be located on the back or bottom of the UPS on a white sticker. we need to know this.

also, there is no fault light. from top to bottom on the Back UPS RS/XS/NS families, the LEDs are as follows:

online
on battery
overload
replace battery

i assume you mean overload. if its overload, and you hear a constant tone when this LED comes on, it indeed is being overloaded. please confirm the model and LEDs. thanks!

BillP
Administrator Administrator
Administrator
0 Likes
0
160

Re: Could someone please help me?

This reply was originally posted by Angela on APC forums on 6/2/2009


ok so that is the model of the UPS? because that is not an APC model..so thats why i am confused.