Support forum to share knowledge about installation and configuration of APC offers including Home Office UPS, Surge Protectors, UTS, software and services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-2805:08 AM. Last Modified: 2024-03-2701:12 AM
Back-UPS RS 900 no lights
The unit was working for about six months and I took it out of service -- now I'd like to use it again and when I plug it in, there are no lights, nobody is home.
Circuit breaker is intact, no beeps, nada.
There is power on the surge side, but nothing on the battery side, so it's basically a very expensive power strip 😞
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-2805:08 AM. Last Modified: 2024-03-2701:12 AM
There are a few Back-UPS models that must have a good (and charged) battery in place before they'll start up. It's been a while, but I'm pretty sure my Back-UPS RS 800 refused to power up after its batteries failed.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-2805:08 AM. Last Modified: 2024-03-2701:12 AM
There are a few Back-UPS models that must have a good (and charged) battery in place before they'll start up. It's been a while, but I'm pretty sure my Back-UPS RS 800 refused to power up after its batteries failed.