Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84753members
354181posts

unable to get power draw from AP7801 via SNMP

APC UPS Data Center & Enterprise Solutions Forum

Schneider Electric support forum for our Data Center and Business Power UPS, UPS Accessories, Software, Services, and associated commercial products designed to share knowledge, installation, and configuration.

net_tech_apc
Crewman
Crewman
0 Likes
0
120

unable to get power draw from AP7801 via SNMP

This was originally posted on APC forums on 4/2/2015


According to this KB

http://www.schneider-electric.us/sites/us/en/support/faq/faq_main.page?page=content&country=US〈=en&i...

I should be able to obtain phase/bank load measured in tenths of Amps

My 7801 is running

MB:v3.9.2
PF:v3.7.4
PN:apc_hw02_aos_374.bin
AF1:v3.7.4
AN1:apc_hw02_rpdu_374.bin
MN:AP7801 HR:B2

I am unable to fine object Identifier rPDULoadStatusLoad (.1.3.6.1.4.1.318.1.1.12.2.3.1.1.2)

 

Any help is greatly appreciated 

Attachments