SURTD5000XLI

Notifications

APC UPS Data Center & Enterprise Solutions Forum

Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

5060

196

112

108

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to APC UPS Data Center & Enterprise Solutions Forum

317

Link copied. Please paste this link to share this article on your social media post.

Hi!

First of all, thank you for accepting me in the community, and Second I'm very sorry for my written English. I am from Argentina and we have a wide network with Communication Nodes secured by UPS APC. I write because we have a problem with a recently installed battery packs in a UPS APC 5000XLI.

With the new battery pack (changed without powering off the UPS to maintain network availability) it continue sending the events

06.12.2016	11:23:29	UPS: A discharged battery condition no longer exists.
06.12.2016	11:23:28	UPS: The battery power is too low to support the load; if power fails, the UPS will be shut down immediately.

The runtime has increased for a few minutes (From to to 9 minutes). Is there a step-by-step to reset that alarm? or just wait to the UPS to take acknowledge that it has brand new batteries?

Hope you understand me and you could give some advices...Thanks!

Replies 0

To The Top!