MIB collection frequency

Anonymous user · ‎2021-06-28

Hello,

I am trying to read load data using SNMP (the rPDULoadStatusLoad oid) . Specifically for the AP7998 and AP7941. Do you know if there any limitation on how frequently I can read this MIBs for these models? Is the data being aggregated (averaged or extrapolated) at PDU level before sent? Is there any documentation for that?

Thx

BillP · ‎2021-06-28

i can say that the lowest value you can put on your data log interval setting in the web interface is 1 minute - so the rPDU would log the load each minute in its data log. i dont think there is a limit to how often you can poll the device via SNMP and i dont know of any documentation on this specific question or just SNMP in general with this device and how often you can poll, etc

i will see what i can find in the mean time

See Answer In Context

BillP · ‎2021-06-28

i can say that the lowest value you can put on your data log interval setting in the web interface is 1 minute - so the rPDU would log the load each minute in its data log. i dont think there is a limit to how often you can poll the device via SNMP and i dont know of any documentation on this specific question or just SNMP in general with this device and how often you can poll, etc

i will see what i can find in the mean time