Information Alerts - AP9618

[Anonymous user]

Hi Everyone,

I have setup to email notification accounts; derek and UPS. Derek is my email address and I want to receive all alerts, whereas, my UPS email address I want only critical alerts sent to it (not informational alerts). I logged into the AP9618 and performed the following

1) Selected Notifcation
2) By Group
3) Checked only "Informational Events"
4) Email Receipents
5) Selected the UPS account
6) Selected no notification

Unfortunately there are still informational events/alerts being sent to my UPS email address such as UPS Warmstart, Enviroment controls restored to interface, etc. How can I get this to stop?

Thank you,
D

[BillP]

On that note, do you know if its possible to export/import notification settings? Its fairly tedious to go through and adjust the individual alerts on a few dozen UPS'.

[TheNotoriousKMP_apc]

Hello,

The utility which you will want to use is the INIUtility. That will allow you to upload one config file to multiple devices, but only specific sections which are different on every card. That can be found when you unpack the firmware, or here:

ftp://ftp.apc.com/apc/public/hardware/nmcard/firmware/

[Anonymous user · Accepted solution]

Hi Everyone,

I have setup to email notification accounts; derek and UPS. Derek is my email address and I want to receive all alerts, whereas, my UPS email address I want only critical alerts sent to it (not informational alerts). I logged into the AP9618 and performed the following

1) Selected Notifcation
2) By Group
3) Checked only "Informational Events"
4) Email Receipents
5) Selected the UPS account
6) Selected no notification

Unfortunately there are still informational events/alerts being sent to my UPS email address such as UPS Warmstart, Enviroment controls restored to interface, etc. How can I get this to stop?

Thank you,
D