Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted:
2 weeks ago
IP assigning issue for AP8853 PDU and AP4423 ATS
the PDU and ATS goes to DHCB mode i tried to assign the IP manually using Card Device IP Configuration Utility software and it give me the following error (The IP address could not be set, Please try a diffrent IP)
and i tried sevral IP addresses and it didn't work
Link copied. Please paste this link to share this article on your social media post.
Posted:
2 weeks ago
I’m not clear as to what you’re trying to say but will offer some general advice. Generally speaking in an Enterprise network environment the IP Address is allocated by MAC Reservation vs Fixed IP Address from the router / firewall.
Doing so avoids IP Conflicts, allows remote network attributes to be changed without problems that plague using a Fixed IP.
If you haven’t done so already use this method instead. Obviously this is more complicated if this is not a flat network and incorporates VLAN, Authentication, 802.1X, Port Security etc.