Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Solved
Go to Solution
Link copied. Please paste this link to share this article on your social media post.
I am trying to get Powerchute Network Shutdown working. When I first installed it, I put the wrong time for the shutdown duration (pic attached). I cannot figure out how to change it. I went through the setup for the program and it did not allow me to change it.
Accepted Solutions
Link copied. Please paste this link to share this article on your social media post.
For many setup you would change the setting on the "Virtual Machine and Virtual Appliance, Shutdown and Startup" page
Your screenshot indicates you have configure Prioritization, so you need to make the changes there.
Also from you screenshot I can see that you have configured Advanced UPS. If Advanced UPS configuration is used, the durations for each UPS Setup are also changed to reflect the sum of the respective priority group durations for VM Migration, Startup and Shutdown.
Link copied. Please paste this link to share this article on your social media post.
For many setup you would change the setting on the "Virtual Machine and Virtual Appliance, Shutdown and Startup" page
Your screenshot indicates you have configure Prioritization, so you need to make the changes there.
Also from you screenshot I can see that you have configured Advanced UPS. If Advanced UPS configuration is used, the durations for each UPS Setup are also changed to reflect the sum of the respective priority group durations for VM Migration, Startup and Shutdown.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.