Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-2808:39 AM. Last Modified: 2024-03-1711:54 PM
Battery charging indicator blinking
hello, is anyone can tell me what is the cause of battery charging indicator blinking although when it reach 100% charging.. i just recently replace the battery.. the model is surt8000xli
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-2808:39 AM. Last Modified: 2024-03-1711:54 PM
Hello Mohd,
The blinking battery charge is an indication that the battery runtime is low. This could be from having a high load on the UPS or the batteries not having enough juice. Seeing you just replaced the batteries that would not be the case. Sometimes you need to run a self-test in order for these units to recognize the new batteries. I would try to run a self-test to see if that clears the flashing LEDs.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-06-2808:39 AM. Last Modified: 2024-03-1711:54 PM
Hello Mohd,
The blinking battery charge is an indication that the battery runtime is low. This could be from having a high load on the UPS or the batteries not having enough juice. Seeing you just replaced the batteries that would not be the case. Sometimes you need to run a self-test in order for these units to recognize the new batteries. I would try to run a self-test to see if that clears the flashing LEDs.