APC SURT 8000 xli fault code

Notifications

APC UPS Data Center & Enterprise Solutions Forum

Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

5060

196

112

108

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to APC UPS Data Center & Enterprise Solutions Forum

738

Link copied. Please paste this link to share this article on your social media post.

Hello! I know this is not an information consumer should know, but my case is not trivial. What I have - an UPS out of warranty, few years it was just lied in a corner powered down.

Now I try to power it up. It started up with no loads seems ok. Then I connect input power, and it shows Fault led and error code is 01001 (upside-down). I connect a load to ups (about 1000 VA) and it beeps about low battery and keep it working online 5 minutes.

The nearest service is far away, I think the game is not worth the candle to transport it. So please could you say is this error could be fixed "in place" (say, by changing batteries to all new) or it requires complex diagnostics?

Replies 0

To The Top!