APC AP8953 Management interface constantly reboots after https enabled

Notifications

Join our "Ask Me About" community webinar on May 20th at 9 AM CET and 5 PM CET to explore cybersecurity and monitoring for Data Center and edge IT. Learn about market trends, cutting-edge technologies, and best practices from industry experts.
Register and secure your Critical IT infrastructure

APC UPS Data Center & Enterprise Solutions Forum

Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

5060

196

112

108

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to APC UPS Data Center & Enterprise Solutions Forum

413

Link copied. Please paste this link to share this article on your social media post.

Whenever I enable HTTPS on one of my APC AP8953 power bars the management card just constantly reboots every 10 seconds or so. There is just enough time to get in via the serial port and do a resettodef which then resolves the issue. However I want to run with https and didn't have this issue on the other 19 power bars that were recently installed. Any one have any ideas on how this can be resolved. Thanks

Replies 0

To The Top!

APC AP8953 Management interface constantly reboots after https enabled

APC AP8953 Management interface constantly reboots after https enabled

This is a heading