Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2022-06-2808:36 AM
AP9630 OID UPSOUTPUTSTATUS
Good Day,
I have AP9630 SNMP card.
There is an OID UPSBasicStateOutputStatus as mentioned in attached screenshot contain 64 flags/bits, each bit is representing alarm status the data type if OctectString, I wish to have single OID of every single flag.
Kindly Advise, The Firmware version of the card is attached in the screenshots.