SpaceLogic KNX Forum
Schneider Electric SpaceLogic KNX forum to get support and share knowledge including selection, installation and troubleshooting for spaceLYnk, Wiser for KNX, eConfigure KNX, SpaceLogic KNX Hybrid module and other topics.
Posted: 2017-12-23 12:05 AM . Last Modified: 2024-07-14 11:51 PM
Link copied. Please paste this link to share this article on your social media post.
Dear All
This touch panel has been active for some time on the project, For reasons unknown to us. The GRUB Loading stage 1.5. message screen appears on the Touch-Screen for a few moments and then reset. As far I know I need IMAGE file.
Regards
Link copied. Please paste this link to share this article on your social media post.
Dear Danial,
it seems you are right in the way that you need a new firmware but to be very sure please place in BFO a dedicated case to get support.
kind regards
Thomas
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Dear Thomas
I do not have access to BFO because of sanctions in Iran.
Best regards
Link copied. Please paste this link to share this article on your social media post.
Hello Danial,
I will sent you a mail because I cant attach here a Word-Document which is needed for our supplier.
Kind regards
Thomas
Link copied. Please paste this link to share this article on your social media post.
Technically you can - after clicking "Reply", just click "Use advanced editor" and then click "Attach"
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.