Controlling a NF3500G4 with a DMX signal

Notifications

Launch of Consumer/Home Owner registration process!
We are pleased to announce the commencement of the Consumer/Home Owner Registration Process on Community. Consumers/Home Owners may now proceed to register by clicking on Login/Register. The process is straightforward and designed to be completed in just a few steps.

SpaceLogic C-Bus Forum

Schneider Electric forum about the C-Bus platform to get support and share knowledge including Network Automation Controller (NAC), Application Controller (AC) at selection, installation and troubleshooting sides.

Search in

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to SpaceLogic C-Bus Forum

Start a Topic

326

Link copied. Please paste this link to share this article on your social media post.

I have 5 panels with the G4 controller but I try to control them by DMX, I already assigned the breakers to each zone and then assigned a DMX slot as an input to that zone, but nothing happens, I don't know what I'm not configuring, I've been working on this for almost a month and I can't get it to work and there isn't much documentation on the internet.

On the green screen of the G4 controller the letters RX appear blinking but that is all.

Replies 0

never-displayed

You must be signed in to add attachments

never-displayed

You’ve reached the end of your document

Ask our Experts

Didn't find what you are looking for? Ask our experts!

My Dashboard

Check out the new Feeds and activities that are relevant to you.

To The Top!