SEPAM S80 to M81 conversion

Notifications

Join our "Ask Me About" community webinar on May 20th at 9 AM CET and 5 PM CET to explore cybersecurity and monitoring for Data Center and edge IT. Learn about market trends, cutting-edge technologies, and best practices from industry experts.
Register and secure your Critical IT infrastructure

Protection & Control

Schneider Electric support forum about Protection Relays, Substation Controllers & RTUs, Arc Flash Devices & Systems in Medium Voltage and Low Voltage. A place to get support on product selection, installation, commissioning and troubleshooting.

Invite a Co-worker

Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.

Send Invite Cancel

Top Experts

User

Count

Invite a Colleague

Found this content useful? Share it with a Colleague!

Invite a Colleague

Back to Protection & Control

485

Link copied. Please paste this link to share this article on your social media post.

Hi I have a SEPAM S80 which has been incorrectly specified and it should be a an M81. Does anyone know if this could be reprogrammed? Our Factory in Leeds has SEPAM facility but im unsure if this can be done if teh hardware is the same etc?

Replies 0

never-displayed

You must be signed in to add attachments

never-displayed

To The Top!

SEPAM S80 to M81 conversion

SEPAM S80 to M81 conversion

This is a heading