How to replace a MicroLogic 6.0X Control Unit

[x22423344]

Hello everyone,

I recently encountered an issue at a project site where the MicroLogic 6.0X control unit display is flickering. Based on our assessment, it is likely a control unit malfunction.

May I ask if there is any installation manual or instructional video available in case we proceed to replace the control unit ourselves?

There are multiple sensor wiring harnesses connected at the rear of the unit, and we are unsure of the correct procedure for disconnection and reinstallation.

Thank you all in advance for your support.

[Manon_Chaboud]

Hello @x22423344, thank you for your post, we'll come back to you!