EcoStruxure Power Commission V 2.28.0 Release Notes

[Gopi.S]

Hello All, Kindly find the New Release notes for EcoStruxure Power Commission V 2.28.0.
What's New?

1. Simpler and faster way to capture end user site address details through autocomplete search.
2. New Firmware Integration:
1. Front Display Module - FDM121 (v004.000.013)
2. IFE Gateway (V4.10.0)
3. EcoStruxure Panel Server (v001.006.000)
3. IDMTG (Inverse Definite Minimum Time Ground Fault) Digital Module available for installation for MasterPact MTZ.
4. Configure basic protection settings for MasterPact NT/NW via Service Interface.

New devices integrated

1. Gas Monitoring Module-PTM100: Discovery, Identification, Configuration, Device Check-up, Communication Test, Backup and Restore supported.
2. EcoStruxure Panel Server-Entry (PAS400) : Discovery, Identification, Configuration, Device Check-up, Communication Test, Firmware upgrade, Backup and Restore supported.

Improvements

1. View Automatic Trip Curve Test (ATCT) results in the New Project Report for MasterPact NT/NW, Compact NSX and MasterPact MTZ range of breakers.
2. MicroLogic Replacement (Upgrade/Downgrade/Swap): Recover all historical data (critical, major and minor) from the original Micrologic to the new one, to ensure correct alarms and events on breaker maintenance.
3. TransferPacT Active: Transfer Test, Device Alarm and Availability Status supported.
4. Additional contextualization parameters for SmartLink link Modbus Refresh
5. View identification details for devices unknown to EPC-D discovered under EcoStruxure Panel Server.
   
   
   

[S-W · Accepted solution]

Thank you for sharing the knowledge @Gopi.S.
We're sure our curious community look forward to learn more electrical distribution and software know-how!