Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84828members
354283posts

Mau narik data metering dari powerscada ke power meter expert perlu nambah partnumber apa?

PLC Club Indonesia

Wadah diskusi seputar PLC,HMI, SCADA dan semua hal seputar otomasi pada proses industri, baik mengenai hal teknis, informasi terbaru dan juga seputar bisnis. Forum ini terbuka unutuk semua system integrator industrial di Indonesia

basadi
Ensign
Ensign
0 Likes
1
594

Mau narik data metering dari powerscada ke power meter expert perlu nambah partnumber apa?

Mau narik data metering dari powerscada ke power meter expert perlu nambah partnumber apa?

1 Reply 1
GY_BU
Lt. Commander
Lt. Commander
0 Likes
0
593

Re: Mau narik data metering dari powerscada ke power meter expert perlu nambah partnumber apa?

apakah maksud pertanyaannya menarik data dari device power meter ke Power SCADA? kalo iya di Power SCADA sudah ada driver protocol built in untuk bisa connect dengan power meter device sehingga tinggal tunning protocolnya untuk bisa berkomunikasi seperti: baud rate, parity, dkk ( apabila menggunakan protocol serial ) sedangkan untuk tipe protocol ethernet tinggal setting IP saja