Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84449members
353655posts

Mau baca status port connecxium Di citechscada apakah harus configuration Di setup editor?

PLC Club Indonesia

Wadah diskusi seputar PLC,HMI, SCADA dan semua hal seputar otomasi pada proses industri, baik mengenai hal teknis, informasi terbaru dan juga seputar bisnis. Forum ini terbuka unutuk semua system integrator industrial di Indonesia

basadi
Ensign
Ensign
0 Likes
1
639

Mau baca status port connecxium Di citechscada apakah harus configuration Di setup editor?

Untuk baca status port connexium bisa menggunakan protocol SNMP. Perlu install driver SNMP II dulu di citect nya.​

 

1 Reply 1
Oncom
Commander
Commander
0 Likes
0
623

Re: Mau baca status port connecxium Di citechscada apakah harus configuration Di setup editor?

@basadi perlu untuk setting di setup editor atau di file  CITECT.INI untuk konfigurasi SNMP nya.