Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Solved
Go to Solution
Link copied. Please paste this link to share this article on your social media post.
Hello,
A customer cannot connect to a PacDriveM controller using the Diagnostics tool.
He opens Diagnostics and selects PacDriveM - Gateway dialog - Communication parameter
The customer cannot create a new connection because he cannot see any entry in the Device list.
Normally the list has many entries, like in the picture below.
Thanks for your support.
Accepted Solutions
Link copied. Please paste this link to share this article on your social media post.
For some users, the problem can be solved by starting Diagnostics with administrator rights.
Follow these steps:
1. Exit EPAS-4 Gateway service
2. Start Diagnostics with Administrator rights.
Link copied. Please paste this link to share this article on your social media post.
For some users, the problem can be solved by starting Diagnostics with administrator rights.
Follow these steps:
1. Exit EPAS-4 Gateway service
2. Start Diagnostics with Administrator rights.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.