Ask our Experts
Didn't find what you are looking for? Ask our experts!
Launch of Consumer/Home Owner registration process! We are pleased to announce the commencement of the Consumer/Home Owner Registration Process on Community. Consumers/Home Owners may now proceed to register by clicking on Login/Register. The process is straightforward and designed to be completed in just a few steps.
Support forum for Machine and Motion Control solutions, including Lexium MC12 and robotics, PacDrive, Modicon PLCs and I/Os, EcoStruxure Machine Expert Twin, … - from design, implementation to troubleshooting and more, by Schneider Electric
Search in
Link copied. Please paste this link to share this article on your social media post.
Posted: 2024-03-31 07:12 PM
Hello,
I have a problem in one of new TM241CE40R controller. I couldn't set the IP Address of that controller.
Right now, the current IP is 0.0.0.0 by DHCP. I have tried some change in setting like:
1. Upgrade firmware to v5.1.9.25 via PC or SD Card with fix IP (example : 192.168.0.10)
2. Change communication setting when connecting to PC
3. Using post configuration
But none of those method worked and the IP still same (0.0.0.0). I have also tried to another new TM241CE40R controllers, but I haven't found a problem like that. Can it be solved ?
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2024-04-04 04:39 AM
Hi. Just a question, du you have a cable in the Ethernet port and, if so, is the other end of the ethernet cable connected to equipment.
If no cable is attached to the Ethernet port, the IP address would be 0.0.0.0
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2024-04-17 02:16 AM
Hi, thank you for your reply.
When I checked the IP address, there's no connection to the ethernet port of controller.
I also tried to check the connection via ethernet using default address of the controller, but still got no connection.
So, after I checked again, turns out there's a pin in ethernet port of controller that bent slightly.
When I test again after a little fix, the PC can connect to the controller via ethernet connection.
Therefore, there's a little problem in the hardware controller.
Link copied. Please paste this link to share this article on your social media post.
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.